Gross weight (including packaging)(kg) : 27kg; Product size (cm) : 33*26*40cm; Zcb-700d electric oil pump is a double-pump single-oil high-pressure oil pump, oil tank and other components of ultra-high pressure oil pump, with small volume, low pressure, light weight, simple structure, easy to use and other advantages. The pump in order to be able to observe the pressure changes at any time during the operation, a special device for the standby interface of pressure gauge, so that the user can install the pressure gauge. Usage: 1. The pump can be used as a hydraulic pump for various hydraulic instruments. 2. After the pump is equipped with other hydraulic tools, it can be used for lifting, pressing, bending, bending, straightening, shearing, assembling, disassembly and other work. Reduce labor intensity and improve work efficiency. Ii. Method of use: Open air nut shall be used, the switch on the oil collecting block shall be opened, the power shall be plugged in, and the quick connector shall be put on the quick head of the matched hydraulic instrument. Press the power switch, wait for the motor to rotate for 1-2 minutes, turn off the switch and put it in the pressurized state. At this time, the output hydraulic oil will carry out various work, and the output hydraulic oil will self-pressurize with the increase of the load to carry out various work until 70MPA. After the completion of the work, open the switch for unloading. After the completion of the hydraulic oil return, remove the quick connector sleeve, screw the air discharge nut, remove the power cable, and turn off the switch. 1. No. 7 hydraulic oil (mechanical oil) for oil pump: the thinner the better. 2. Oil storage capacity must be within the range above the oil window. 3. For each refueling and oil change, the oil filter net above 80 mesh must be used for filtration, and the oil tank shall be cleaned when changing. The oil change period is six months. 4. Operating oil temperature: 10 ° C to 50 ° C. 5. Before starting the electric pump, open air nut shall be used. Open the switch and place it in the unloading position. 6. If the motor temperature is found to be too high during use, it should be stopped. Allow to cool by itself before use. 7, the pump has been adjusted before leaving the factory, do not arbitrarily high-profile, need to readjust, with the help of pressure gauge. 8. The high pressure tubing is delivered from the factory and tested by 105MPA. However, the hose is easy to age, so the user needs regular inspection, generally for six months, frequent use for three months, 87.5mpa pressure test during the inspection, if there is damage, protrusions, leakage phenomenon, can not be used. 9. The bearings are generally cleaned once every six months, and grease should be added during assembly.